Brinkmann MAXFIRE 800-2200-0 - Manual (Page 2)

Step 1: Make sure trigger switch is not locked in the ON position.
Step 2: Plug the AC charger or DC charger/adapter into the socket located on
the base of the spotlight handle as illustrated.
Step 3: For DC Charger/Adapter:
Plug the other end of the DC charger/adapter into a cigarette lighter
receptacle.
For AC Charger:
Plug the other end of the AC charger into a wall outlet.
Parts List
1 Dual Xenon spotlight
2 120-volt AC charger
3 12-volt DC charger/adapter lighter plug
Owner’s Manual
OPERATING INSTRUCTIONS
READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER’S MANUAL
BEFORE OPERATING SPOTLIGHT.
Inspect contents of the box to ensure all parts are included and undamaged.
Step 1: Depress trigger switch in handle to turn spotlight ON.
Step 2:
Release trigger switch to turn spotlight OFF.
Continuous Beam Using Lock Button:
Step 1: For a continuous beam, depress trigger switch and slide the lock button
to the LOCKED position.
Step 2: To unlock and turn spotlight OFF, slide the lock button to the
UNLOCKED position.
NOTE: To lock the Dual Xenon in the OFF position, release trigger switch, then
slide the lock button to the LOCKED position.
WARNING: Always turn spotlight off when not in use.
Switching Between Single and Dual Beams:
Step 1: For single beam, slide switch on back of light to one dot, as illustrated.
Step 2: For dual beam, slide switch on back of light to two dots, as illustrated.
NOTE: The Dual Xenon will burn for approximately 40 minutes if using both
beams, or approximately 85 minutes if using only one beam.
1
2
3
To Operate
2
Trigger
Switch
LED Indicator
Lock
Button
Beam
Switch
Single
Beam
Dual
Beam
Unlocked
Locked
To Charge
INSTR-800-2200-0_Dual Xenon.qxd 6/24/03 3:23 PM Page 3