Gamber-Johnson 7160-0062 - Manual

Toyota Tundra Vehicle Base, '07 and Newer
INSTALLATION INSTRUCTIONS
Product Date Form #
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
7160-0062
08/01/07 INST-342
•You must read and follow all of these installation instructions. Failure to follow the
installation instructions may result in serious bodily injury or death.
•Do not install or use the Toyota Tundra Vehicle Base in the area in which the airbag in the
vehicle may be deployed. The installer and user of the Toyota Tundra Vehicle Base are
responsible for installing and using the Toyota Tundra Vehicle Base outside the area in
which an airbag may be deployed. (See Product Mounting Disclaimer Below)
•Keep these installation instructions with the product and readily available in the vehicle
for future reference of other users of the product.
•Additional copies of the installation instructions can be obtained from Gamber-Johnson.
If you need assistance or have any questions, call Gamber-Johnson at 1-800-456-6868.
•Do not remove warning label from product under any circumstances.
WARNING
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
1. Begin by removing the front seat bolts of the front passenger's seat. Loosen the rear
seat bolts of the same seat.
2. Tilt the seat back enough to slide the the base under the front legs of the seat.
3. Align the cut-outs on the base under the dimple on the
seat leg. The dimples are intended to rest centered in the
cut-outs. Take note of the rectangular notch on each cut-out.
There is a small post on each seat leg that helps to align the
seat when being installed. This post is intended to insert into
the rectangular notch.
FIG. 1
Toyota Tundra Vehicle Base
Cut-out
Cut-out
Rectangular Notch
Sheet 1 of 2