Gamber-Johnson 7160-0512 - Manual

Rev.A INST-612
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
to be used with Gamber-Johnson G1 docking stations, a Pansonic keyboard, or
I-Key keyboard. Installation instructions for other Gamber-Johnson products are
This instruction sheet is for the FZ-G1 keyboard mount only. This mount is designed
provided with each individual product.
INSTALLATION INSTRUCTIONS
Product Revision
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
Printing Spec: PS-001
G1 Riveted Keyboard Mount
Form
7160-0512
Attaching the keyboard to the
keyboard bracket
1. Insert the 1/4-20 x 2" long hex bolt
through the mounting hole on the
keyboard bracket. The mounting hole
has a hex shaped counterbore for the
head of the bolt to sit into.
2. Attach the bracket to the Keyboard
with the pan head screws provided in
the hardware bag. The I-Key keyboard
will use the (4) #8-32 x 1/4" long screws.
The Panasonic keyboard will use the (8)
M3 x 6mm long screws.
3. Next attach the washers and hand
knob in the order shown to the right.
4. Last Attach the Acorn nut to the
end of the bolt to keep the washers
and handle from falling off the bolt
when the handle is loosened to
remove the keyboard.
1/4" acorn nut
bracket
knob
1/4" flat washer
keyboard
hardware
I-Key keyboard
nylon washer
steel washer
mounting
1/4 x 2" hex bolt
© Copyright 2013 Gamber-Johnson, LLC