Gamber-Johnson 7160-0237 - Manual (Page 2)

Adjustment
The MCS-Ergo-Hybrid console box is designed to allow adjustment of the front to back angle for the system. The box
can be tilt towards the front or back by up to eight degrees in each direction (Figure 3a and 3b).
The MCS-Ergo-Hybrid console box is designed to allow adjustment of the height of the system by up to 2.37-inches
(Figure 3c).
To adjust the tilt or height of the console box remove the appropriate socket head cap screws from each side of the box
and tilt or lift the box into the desired position. Secure the box position with the socket head cap screws that were
removed.
Forward Tilt
(a) Rear Tilt
(b) Horizontal
(c)
Figure 3: Tilt adjustment and height adjustment
Mounting Features
Motion Attachments
The MCS-Ergo-Hybrid console box will allow a user to mount any Gamber Johnson motion attachment to the top of the
box. It is recommended that all clevis attachments be mounted to the right most circle pattern to prevent interference
with the clevis knob and top of the console.
Electronics
The MCS-Ergo-Hybrid console box will allow a user to mount the Lind Ruggedized Shut Down Timer (Gamber PN
13791) or the 6 Circuit Power Distribution Block (Gamber PN 7160-0110) without drilling holes.
The MCS-Ergo-Hybrid console box has nine knockout locations to allow the use of several 12V automotive power
sockets (Gamber PN 7160-0063).
Clevis Mount Location
Lind Ruggedized Shut Down
Timer Two Hole Pattern
6 Circuit Power Distribution
Block Four Hole Pattern
12V Automotive Power Socket
Mount Location
Figure 4: Motion Attachment and Electronics mounting points
SHEET 2 OF 3