Gamber-Johnson 7160-0548-xx - Manual (Page 3)

required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
LEG
(DRIVER SIDE)
FRONT PLATE
WIRE CHASE
BACK PLATE
FIGURE 2
A
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
INSTALLATION INSTRUCTIONS:
If the vehicle comes with a center console or center seat, remove it by removing the 1.
four M10 bolts on the transmission hump. (Save the hardware for step 2)
2. Secure the Legs to the transmission hump using the M10 hardware from Step 1. If there
is no center seat/console, the holes are generally plugged. Use M10 hardware provided in
the hardware bag.
NOTE : Letter "D" on one of the legs indicate it secures to the driver side; side with letter "D"
towards front. See Figure 2.
3. Place the console box on top of the legs and slide it to desired position. Secure the
console box to the leg kit using the 3/8 hardware provided
4. Attach the accessories, such as Wire Chase, Armrest, Storage Box etc., to the
Console Box using the hardware provided with them.
TOOLS NEEDED:
Phillips Screw Driver 1.
#10 Allen 2.
M10 Socket/Wrench 3.
3/8 Socket/Wrench 4.
DETAIL A
LETTER "D" ON
LEG (DRIVER SIDE)
© Copyright 2014 Gamber-Johnson, LLC