Gamber-Johnson 7110-0161 - Manual

7110-0161
INSTALLATION INSTRUCTIONS
Product Date Form #
If you need assistance or have questions, call Gamber-Johnson at 1-800-456-6868
ADD ON BRACKET SET
Rev.B INST-375
Product Mounting Disclaimer
Gamber-Johnson is not liable under any theory of contract or tort law for any loss, damage, personal injury, special, incidental or consequential damages for personal injury or other damage
of any nature arising directly or indirectly as a result of the improper installation or use of its products in vehicle or any other application. In order to safely install and use Gamber-Johnson
products full consideration of vehicle occupants, vehicle systems (i.e., the location of fuel lines, brakes lines, electrical, drive train or other systems), air-bags and other safety equipment is
required. Gamber-Johnson specifically disclaims any responsibility for the improper use or installation of its products not consistent with the original vehicle manufactures specifications
and recommendations, Gamber-Johnson product instruction sheets, or workmanship standards as endorsed through the Gamber-Johnson Certified Installer Program.
Step1. Remove all equipment brackets from the assembly by removing the side bolts and washers leaving
only the bottom two brackets, Figure 1a. The remaining assembly should look like Figure 1b. Save all
bolts and washers for use in step 3.
Remove all equipment
brackets.
Figure 1a Figure 1b
Remove side bolts and
washers.
Purpose:
The 7110-0161 Add On Bracket Set is intended to be used
with any StackMaster, ShortStack, StackAbout, FloorMaster, or
FlexMaster products that requires the addition of another radio. The
product is shipped un-assembled and is made up with the parts
depicted in the illustration to the right.
This instruction sheet explains how to assemble the Add On Bracket
Set to the product it is intended to be used with. The illustrations
shown are generic and typical for all StackMaster, StackAbout,
FloorMaster, or FlexMaster products. The instruction sheets assumes
that you are adding the add on set to a previously assembled
StackMaster, StackAbout, FloorMaster, or FlexMaster product. If that
is not the case please combine this instruction sheet with those that
came with the other products to determine proper assembly.
© copyright 2012 Gamber-Johnson, LLC
1/2
(Side bolts and washers
will be reused in Step 3)