Gamber-Johnson 7160-0318-xx - Manual (Page 7)

DOCKING THE COMPUTER
Figure 10
Pg 7
Figure 8
1. Shut down the computer.
2. Make sure the sliding door (located on the
on the back of the computer) has
been fully opened, exposing the computer's
docking connector. (Figure 8)
3. Set computer in the dock:
a. Hook the front of the computer on the front
retainer (Figure 9).
b. Lower the back of the computer
onto the Alignment Pins (Figure 9).
c. Lightly press down on the back of the computer
to ensure it is fully seated.
4. Pull the docking handle towards the left side of the
dock until the latch catches (Figure 10).
(The Push Button latch can be locked for
added security)
5. Boot the computer. If the dock is powered, the
computer is powered and ready for use.
*Docking station will operate with computer screen
opened or closed.
Sliding Door
Docking Connector
Alignment Pins
Docking handle in
"UNDOCKED" position
Figure 9
Front Retainer.
Docking handle in
"DOCKED" position