Gast 34R Series - Manual (Page 2)

Motor Control
It is your responsibility to contact a qualified
electrician and assure that the electrical installation
is adequate and in conformance with all national
and local codes and ordinances.
Select fuses, motor protective switches or thermal
protective switches to provide protection. Fuses act as
short circuit protection for the motor, not as protection
against overload. Incoming line fuses must be able to
withstand the motor’s starting current.
The wiring diagram supplied with the product provides
required electrical information.
Your safety and the safety of others
is extremely important.
We have provided many important safety messages
in this manual and on your product. Always read
and obey all safety messages.
This is the safety alert symbol. This symbol
alerts you to hazards that can kill or hurt you and
others. The safety alert symbol and the words
“DANGER” and “WARNING” will precede all safety
messages. These words mean:
You will be killed or seriously injured if you don’t
follow instructions.
You can be killed or seriously injured if you don’t
follow instructions.
All safety messages will identify the hazard, tell you
how to reduce the chance of injury, and tell you
what can happen if the safety instructions are not
followed.
Correct installation is your responsibility. Make sure
you have the proper installation conditions and that
temperatures are not excessive.
Blocking air flow over the product in any way can
cause the product to overheat.
Mounting
This product can be installed in any orientation.
Mounting the product to a stable, rigid operating surface
and using shock mounts will reduce noise and vibration.
INSTALLATION
Accessories
The product’s external intake filter/silencer (VG2016) will
provide adequate filtration in most applications. Check
filters periodically and replace when necessary. Consult
your Gast Distributor/Representative for additional filter
recommendations.
WARNING
DANGER
Ꮨ
Disconnect electrical power at the circuit breaker
or fuse box before installing this product.
Install this product where it will not come into
contact with water or other liquids.
Install this product where it will be weather
protected.
Electrically ground this product.
Failure to follow these instructions can result in
injury, fire or electrical shock.
WARNING
Electrical Hazard
Plumbing
Connect with pipe and fittings that are the same size or
larger than the product’s threaded ports. Be sure to
connect the intake and exhaust plumbing to the correct
inlet and outlet ports. Ports will not support plumbing.
Install relief valves and gauges at inlet or outlet or both,
to monitor performance. Check valves may be required
to prevent back streaming through the pump.
Electrical Connection
Ꮨ
This product must be properly grounded.
Do not modify the plug provided. If it will not
fit the mating plug, have the proper
installed by a qualified electrician.
If repair or replacement of the plug is necessary, do
not connect the grounding wire to any of the four
wedge lock terminals. The wire with insulation
that is black is the grounding wire.
Check the condition of the power supply wiring.
Do not permanently connect this product to
wiring that is not in good condition or is
inadequate for the requirements of this product.
Failure to follow these instructions can result in
injury, fire or electrical shock.
WARNING
Electrical Hazard
mating plug,