Hahnel Giga T Pro II Wireless Timer Remote - Manual (Page 4)

Receiver
LCD Screen
Power ON/OFF Button
& Channel Selector
Backlight Button ON/OFF
& Channel Selector
LED light
Default Receiver LCD Screen
Transmitter
LED light
Transmitter Button
LCD Screen
Play / Stop Button
Power ON/OFF Button
& Backlight Button ON/OFF
Centre Button to confirm settings
4-Way Joypad
Default Transmitter LCD Screen
Cable
Cable Connector
Transmitter 4-Way Joypad
Centre button to confirm and accept
settings
Arrow buttons. To select the Mode
Settings, eg. Single Shooting,
Continuous Shooting, Delay, Long,
Timer, use left and right directional
arrows
To adjust the values for the timer,
exposure count & intervals or
channels, use the up and down
directional arrows.
Interval Timer Functions
Delay Setting
Long Setting
Interval 1 Setting
N1 Number of Exposures
Interval 2 Setting
N2 Number of Repeats
Seconds
Minutes
Hours
Standard Wireless Remote
Control Functions
Channel Selector
Basic Timer Mode
Bulb Mode
Continuous Shooting Mode
Single Shot Mode
26
25
24
23
22
21
20
19
18
17
16
15
14
13
11
10
12
11
10
9
8
7
6
5
4
3
2
1
Setting up Giga T Pro II
Switching on your Giga T Pro II
Wireless Remote Control
Ensure the camera and remote control
receiver are turned off before connecting.
Attach the receiver to the hot shoe on the
camera.
Connect Giga T Pro II to the remote
control socket of the Camera, using the
correct connector cable included.
To switch On/Off the Receiver, press and
hold the Power Button. Switch on the
camera.
To switch On/Off the Transmitter, press
and hold the Power Button. Note: The
transmitter automatically powers off after
60 seconds of inactivity.
LCD Backlight
On Receiver: Press and hold backlight
Button
On Transmitter: Press and hold backlight
Button
Channel Selection
To communicate between the transmitter
and receiver, both units must be on the
same channel.
The default on both LCD screens displays
the active channel (sample: CH02). To
change channel on the receiver, press and
hold BOTH Channel selector buttons until
the LCD screen flashes. Use individual
channel buttons to change the channel
setting. To set and confirm the channel,
press BOTH channel selector buttons.
To change channel on the transmitter, use
the 4-way joypad to go to Channel
Selector mode and press the centre
button. Adjust using the 4-way joypad, set
and confirm using the centre button.
Refer to FAQ for benefits of additional
channels
9
9
3
A
IRL/GB