HMC Electronics 1673-10S Techspray Canned Air Duster User Manual
Economy duster
Economy Duster
1673
Techspray dusters blow away dust, microscopic contaminants, lint, metallic oxide deposits and other soils that can cause heat buildup or
shorts in sensitive electronics.
Economical HFC-152a duster
Economical HFC152a based duster. Note: not for use on powered electrical equipment, on hot
surfaces, and around open flames or sparks.
Best value — 30% more volume
Lower global warming potential — 10% of HFC-134a
Non-ozone depleting
Moisture free
Zero residue
Safe on plastics
VOC exempt
Velocity – 11.4 m/s
Product Packaging
1673-10S
Economy Duster
10 oz
12 units/case
Instructions
Can must be held in an upright position when spraying. Do not tilt can more than 40 degrees during spraying operation or shake during use. Before use, press actuator to
clear valve of any liquid product. Use short burst to prevent cooling of can. Note: Do not use on photographic negatives without first clearing valve.
Chemical & Physical Properties
Appearance
Colorless gas
Odor
Faint ethereal odor
Flash Point
< -50°C (-58°F)
VOC (EPA)
0%
VOC (CARB)
0%
Boiling Point
-25°C (-13°F)
Density
page 1 / 2
Techspray - US office, P.O. Box 949,
Amarillo, TX 79105-0949,
Tel. 806-372-8523, Toll-free 800-858-4043
Fax 806-372-8750, [email protected]
Documentation Provided By HMC Electronics
33 Springdale Ave. Canton, MA 02021
(800) 482-4440