Humanscale MFlex - Manual

M/Flex INSTALLATION HARDWARE
HSIMF0613
Hex Key A
(2mm)
Hex Key B
(2.5mm)
Hex Key C
(3mm)
Hex Key D
(4mm)
STEP 9: ARM ADJUSTMENTS
FRICTION ADJUSTMENT
If your monitor is particularly
heavy, or after prolonged use, the
Ball Joint Swivel/Tilt Mechanism
may require increased friction. This
can be achieved by tightening the
(3) Ball Joint Friction Screws (A)
using Hex Key C.
WEIGHT ADJUSTMENT
Your monitor should move up and
down easily and should stay in
place once adjusted. If it is difficult
to adjust or moves without
assistance, it is not properly
counterbalanced. Monitor should
not exceed 20 lbs.
1. Use Hex Key C to loosen the
two side screws (C) on the
dynamic arm’s joints. Then use
Hex Key B to loosen the two
top screws (B) on the
dynamic arm.
2. Tighten the two side screws (C)
to achieve the force needed to
hold the monitor weight. After
tightening the side screws to
the desired amount, tighten the
two top screws (B) firmly to
hold the adjustment.
Note: Do not overtighten the
screws as it can damage the screw
head or threads.
3. Move the monitor around to
ensure that movement is
smooth and the arm functions
as desired. If required, repeat
steps 1 and 2 (in order) to adjust
the force as needed.