Humanscale CPU200 - Manual (Page 2)

Step 1:
For CPUs 7” – 12” in Height
Loosen Width Knob and slide Side Bracket
outward. Loosen Height Lock and slide Upper
Assembly to highest position. Center CPU on
Base.
For CPUs 6” – 7” in Height
If you have received the optional Spacer, your
CPU200 will accommodate a CPU as small as
6 inches in height.
Place Spacer between the Base of the CPU200
and the Non-Skid Pad, then loosen the Width
Knob and slide Side Bracket outward. Loosen
Height Lock and slide Upper Assembly to highest
position. Center CPU on Base.
Step 2:
Slide Upper Assembly downward until it sits
snugly on top of CPU. Tighten Height Lock.
Push Side Bracket inward until it fits tightly
against CPU. Tighten Width Knob.
CPU200
Installation Instructions
Side Bracket
Base
Width Knob
Height Lock
Mounting Rails
Upper Assembly
Spacer (optional)
Non-Skid Pad
Height Lock
Width Knob
5/8" Long
Tapping Screws
Track
Mounting Tape
1/4” back
from desk edge
Tabs
Step 1:
Position track approximately 1/4” from edge of desk
with folded tabs facing away from desk edge. Using
Mounting Tape, affix Track to underside of desk.
Attach Track to desk using Tapping Screws.
CPU Installation
Track Installation
Spacer