Bell & Howell S02294A User Manual
Page 6
- iv -
B. If liquid has been spilled into the product.
C. If the device has been exposed to rain or water.
D. If the device does not operate normally when the operating instructions are fol-
lowed. Adjust only those controls that are covered by the operating instructions
since improper adjustment of other controls may result in damage and will often
required extensive work by a qualified techinician to restore the product to nor-
mal operation.
E. If the device has been dropped or the cabinet has been damaged.
F. If the device exhibits a distinct change in performance, indicating a need for
service.
14. Make sure that the wall outlet is near the scanner and easily accessible.
15. The main plug on this equipment must be used to disconnect main power.
16. Use the standard cable attached to this scanner. Otherwise, use cables that meet the
following requirements.
Cable
SVT or SJT 18/3
AWG Less than
1.6 m long
H05VV-F or
H05VVH2-F
Area
North America
Europe
Rating
120V
15A
230V
(220-240V)
10A
Connector
IEC320 type
EN60320 type
Plug
NEMA 5-15P
Use the required
e q u i v a l e n t f o r
each country