Bell & Howell S02294A - Manual (Page 16)

Image Scanner User's Manual
- 8 -
Caution: Confirm that the DIP switches on the rear of the scanner
are in the original position as shown right. If the settings
have been changed, correct the settings, otherwise the
scanner may not work correctly. Note : Switch 3 may be in
the ON position if you are not using SCAM — if this is the
case, the setting is correct.
1. Push the power switch at the front of the
scanner.
2. Confirm that the switch is set as shown in
the illustration.
If you want to turn the power off, push the
power switch again.
Power
On Power
Off
¡ Turning the power on
¡ Initializing the scanner
ON
«
Original position
1 2 3 4 5 6 7 8
OFF : with SCAM
ON : without SCAM
Generally, you do not have to initialize the scanner. However, when you change the SCSI ID or
DIP switch settings while the scanner is on, you do need to initialize the scanner.
You can initialize the scanner not only by turning the power off and on but also by pushing the
reset switch at the rear of the scanner.
1. Push the reset switch using a tapered tool
such as the tip of a mechanical pencil.
2. Confirm that the four indiators light for a
few seconds. This means the scanner is
intializing.
03_IS430-BODY 97.5.8, 5:35 PM Page 8 PageMaker 5.0J