Options, Red lamp unit – Bell & Howell S02294A User Manual
Page 44
Image Scanner User's Manual
- 36 -
Options
¡
Red lamp unit
2
3
1
1. Initialize the scanner to return the carriage
to its original position.
2. Turn the power off and disconnect the
power cord.
3. Open the document feeder.
4. Remove the lamp cover.
5. Remove the connector cover.
6. Disconnect the connector.
7. Hold the right side of the lamp and pull it up
while sliding it to the left.
Caution:
Do not touch the middle of the lamp
unit. Hold the green parts only.
8. To attach the red lamp unit, go backwards
through the previous steps.
You can use the optional red lamp unit to skip the OCR red images.
Replace the lamp unit with the optional red lamp unit as follows.
Warning:
E
Never change the lamp unit with the scanner plugged in.
E
The lamp becomes very hot. Wait for about five minutes aftter turning the power off to let
the lamp cool off.
03_IS430-BODY
97.5.8, 5:37 PM
Page 36
PageMaker 5.0J