HYDAC CSI-F-10 - Manual (Page 57)

GSM Radio Module CSI-F-10 Page 57
Status 29.01.2009 HYDAC ELECTRONIC GMBH Part.-Nr.: 669752
7 Configuration Using CMWIN PC Software
Configuration of the CSI-F-10 and implementation of the basic settings can also be
carried out using the "CM Manager“ from a PC.
The "CM Manager" is a component part of the CMWIN HYDAC PC software, starting
with Version 3, and provides you with various tools and functions for the connecting,
configuring, parameterizing and outputting of CM devices.
7.1 Actions
7.1.1 Display Device Status
• Status
The "Status" indicates the current condition of the device. The individual
conditions can be be specified in greater detail via the following table.
Ready No active error present, device is ready for operation
Stand-By No active error present, but device is currently not ready for
operation; it may be that individual device functions are switched
off or the device is in a startup phase, etc.
Minor error A minor error is present which can be acknowledged.
Moderate error A medium-serious error is present, which may possibly be
eliminated by switching On/Off.
Serious error A serious error is present; the unit must be sent in to the
manufacturer.
• Status code
The "Status code" is dependent on the CM Program present in the device and
reflects the conditions of the Boolean output values used in the program.
For this, the Boolean output values are displayed from right to left in ascending
binary sequence, i.e. the lowest-value bit corresponds to the Boolean output
value 0.
Example:
0 = No Boolean output values used in the program
1 0 1 0 = Boolean output value 0 = 0 (LSB)
Boolean output value 1 = 1
Boolean output value 2 = 0
Boolean output value 3 = 1 (MSB)
• Status text
The "Status text" indicates whether or not a CM Program is available in the
device.
No script loaded No CM Program is available in the device.
Script is loaded A CM Program is available in the device.