HYDAC CMWIN - Manual (Page 11)

CMWIN ENGLISH Page 11
Edition 06/2007
2.6.2 Switching on or switching off the pass-through mode
The pass-through mode is required if communication is required with the SMART sensor
connected to the HMG directly from your PC.
• Click on "Pass-through mode" in the interface settings window.
• If it is possible to switch the pass-through mode both on or off at one port (or at
more than one), a new window opens to switch the pass-through mode on or off.
• In the dropdown menu select the port connected to the SMART sensor for which
you wish to switch the pass-through mode on or off.
• Click on "Switch on" to switch on the pass-through mode for the selected port or
on "Switch off" to switch off the pass-through mode for the selected port.
• An information window opens which you must confirm with "OK".
2.6.3 Switching on or switching off the multisensor mode
The multisensor mode is required if several sensors with a clearly allocated bus address are
connected to the same interface.
• Click on the box in front of "Multisensor mode“ to activate or deactivate the
multisensor mode.
• The bus address can be set by clicking "Set bus address".
• After estabishing a link with the SMART sensor you can change the bus address of
the sensor by clicking on "Set bus address“ on the left side of the main window.
• In both cases select the required setting in the dropdown menu.
• Important: in the multisensor mode some functions are restricted.