INCRA Miter Express - Manual (Page 8)

Made in America by:
Taylor Design Group, Inc.
✦
P.O. Box 810262
✦
Dallas, Texas 75381
✦
Tel: (972) 242-9975
✦
Fax: (972) 243-4277
✦
Web Site: www.INCRA.com
Printed in the U.S.A.
✦
© 2005 Taylor Design Group, Inc.
✦
INCRA is a registered trademark of Taylor Design Group, Inc.
INCRA products are protected by one or more of the following U.S. Patents: #4,793,604, #4,930,221, #5,195,730 #5,275,074,
#5,423,360, #5,716,045, #6,237,457, #6,557,601, #6,672,190 Other patents granted or pending.
warranTY
Taylor Design Group, Inc. warrants this product for one year from date of purchase. We will repair any defects due
to faulty material or workmanship, or at our option, replace the product free of charge. Please return the failing
component only, postage prepaid, along with a description of the problem to the address below. This warranty
does not apply to parts which have been subjected to improper use, alteration, or abuse.
07/05
8
FIG. 23 Hold down clamp assembly
INCRA Hold Down Clamp
Open the INCRA Hold Down Clamp hardware bag and
assemble the clamp as shown in Fig. 23.
The INCRA Hold Down Clamp slides into either of the (2)
T-slots on the Miter Express to provide a secure grip on
your work piece, large or small. Either end of the clamp
can be used to clamp your workpiece. Just slide the
clamp into the selected T-slot and tighten the clamping
knob, Fig. 24.
2
FIG. 24 Hold down clamp in use
¼-20 Clamping knob
¼” Washer
Clamp body
¼-20 Hex bolt
Pivot barrel
CAUTION: Never allow any part of the INCRA
Hold Down Clamp to cross the line of cut.