INCRA Telescoping Fence - Manual

1 ⁄ 11 4 ⁄⁄ ”-20 X 3 ⁄ 33 8 ⁄⁄ ”
SOCKET HEAD
SCREWS
4” FENCE
EXTENDER
EXTENDER
BAR
”
FLUSH
HERE
“SPECIAL EDITION” Telescoping Fence Addendum
Your new “Special Edition” INCRA Miter Gauge now includes a telescoping fence and Flip Shop Stop.
These upgrades replace the fence and stop described in the owners’s manual. Follow the steps below
to set up and use your telescoping fence.
Fence Extender Assembly
Loosely install (1) 1 ⁄ 4 ⁄⁄ -20 x 3 ⁄ 33 8 ⁄⁄ ” socket head fastener with
washer and rectangular nut to the left end of the fence and
slide extender bar into fence with the scale face up. (The
higher numbers on the scale should go in first.) Loosely
install (2) 1 ⁄ 4 ⁄⁄ -20 x 3 ⁄ 33 8 ⁄⁄ ” socket head screws with washers
and rectangular nuts to the 4” fence extender and slide
onto the end of the extender bar. Position the 4” fence
extender flush with the end of the extender bar and tighten
all (3) fasteners, Fig 2.
2
Fence Extender Operation
For stopped cuts beyond the range of the standard fence,
clamp the INCRA Flip Shop Stop to the 4” fence extender.
Now loosen the 1 ⁄ 11 4 ⁄⁄ -20 socket head screw located at the
left end of the fence and slide the 4” fence extender to
the left. Tighten the fastener when you reach the desired
scale reading. To set the scales for accurate readout,
set the protractor to the desired angle, then measure the
distance between the blade and the stop surface on the
flip arm. Slide the scale to read this measurement directly
under the end of the fence, Fig. 3. Slide the extender bar
out to also adjust the overlapping scale if required.
3
092002
Made by: Taylor Design Group, Inc., P.O. Box 810262, Dallas, Texas 75381 Web Site: www.incra.com
© 2002 Taylor Design Group, Inc. INCRA is a registered trademark of Taylor Design Group, Inc.
FIG. 2 FIG. 2
1 FIG. 1 Attach Fence to Miter Gauge
Using the (2) 1 ⁄ 4 ⁄⁄ -20 x 1 ⁄ 2 ⁄⁄ ” socket head screws with
washers and rectangular nuts, attach the fence to the fence
mounting bracket. Slide the fence to a position that leaves
safe clearance between the fence and blade, then tighten
the (2) fasteners, Fig. - 1.
FIG. 3 READ
SLIDE SCALE
TO READ
BLADE TO STOP
MEASUREMENT
NOTE:
If you are adding the fence extender bar and 4” fence
piece to an existing FlipStop fence, it is necessary to drill
a 17 / 17 17 64 // ” diameter hole (clearance hole for 1 ⁄ 11 4 ⁄⁄ -20 fastener)
at each end of your FlipStop fence using the dimension
shown in Fig. 4. The hole should be centered on the
groove located on the FlipFence extrusion.
FIG. 4