INCRA IBOX - Manual

Manufactured by Taylor Design Group, Inc. P.O. Box 810262 Dallas, TX 75381 ©2012 by Taylor Design Group, Inc. All rights reserved.
° Before using the INCRA IBOX, read and follow all instructions
and safety information in this manual.
° When using the INCRA IBOX in conjunction with any other tool,
first read and follow all instructions and safety information in that
tool’s owner’s manual.
° Always turn off the power and make sure that the bit or blade is
fully stationary before moving any part of the INCRA IBOX to
any new setting.
° Always use a wooden handscrew clamp to secure your workpiece
to the INCRA IBOX before making any cut.
° Before making a cut, always make sure that the blade guards are in
place and that the fasteners that secure the stock ledges and blade
guards are securely tightened.
° Wear safety glasses, hearing protection and follow all normal shop
safety practices.
° When using the INCRA IBOX with other tools, make sure that all
safety guards and other safety equipment supplied by the manufac-
turer of that tool are securely in place and functional. Never let the
INCRA IBOX interfere with another tool’s safety equipment.
° Keep hands safely clear of the bit or blade.
° DO NOT alter or modify the INCRA IBOX
° Do not attempt to use the INCRA IBOX with a “wobble” dado
blade.
° Do not attempt to use the INCRA IBOX with any cutter smaller
than 1/8”.
° If using with a SawStop table saw, put the SawStop in the Bypass
Mode before calibrating, adjusting, or checking blade clearances.
Return it to normal operation before making a cut.
TM
TM TM
O wner’s M anual
w w w . i n c r a . c o m
Important safety instructions for using the INCRA IBOX SAFETY
Before using the INCRA IBOX,
read and follow all of the
instructions and safety infor-
mation in this owner’s manual.
by
From delicate 1/8” fingers to bold 3/4” joints to exciting new
box joint variations, your New INCRA IBOX is designed to
provide the perfect resource for your next joinery task. The
dual-pitch lead screw driven positioning engine controls both
pin width and spacing with a single adjustment knob while
INCRA’s GlideLOCK™ adjustable miter bar provides smooth
tracking at either your table saw or router table. Before using
your New IBOX, please take the time to read this manual and
be sure to watch the included DVD for some exciting new box
joint techniques, tips and tricks.
CONteNts
safety ................................................................ 1
Preliminary setup ............................................ 2
setting up at the table saw ............................ 3
setting up at the Router table ....................... 4
stock Ledges, Blade Guards & Backing Board .... 5
Operations – Cutting a Box Joint .................... 7
tips and techniques ......................................... 12