INCRA Pro II Fence - Manual

Fig. 1
Fig. 2
Fig. 3
You have purchased the Incra Jig Ultra equipped with the
new Pro II Joinery Fence System, steel fence mounting bracket
and Incra Shop Stop. These components represent an
upgrade and are not described in the standard owner’s
manuals. The following instructions will be used in place of
the referenced instructions from the owner’s manuals.
Mounting the Incra Pro II Fence
(Replaces Mounting the Incra Pro Fence to the Incra Jig Ultra or
Ultra Lite from page 4 of the Incra Pro Fence System Owner's
Manual and as shown in step 2 from page 4 of the Incra Jig Ultra
Owner's Manual.)
Carefully slide the carriage into the base and pull the carriage clamp
up into the locked position. Place a
1 ⁄ 4 " washer on each of the (2)
1 ⁄ 4 -20 x 1 ⁄ 2 " socket head screws and insert through the slotted holes
located on the steel fence mounting bracket. Loosely thread on the
1 ⁄ 4 -20 rectangular nuts, then slide the nuts into the T-slot located on
the rear of the Pro II fence. Position the fence so that the carriage is
approximately centered on the fence length and tighten the (2)
mounting screws with the supplied hex tool, Fig. 1.
INCRA Pro II Joinery Fence System Upgrade Addendum
Installing the Extender Bar
(Replaces Installing the Extender Bar from page 6 of the INCRA
Pro Fence System Owner's Manual.)
Place a 1 ⁄ 4 " washer on the 1 ⁄ 4 -20 x 3 ⁄ 8 " socket head fastener and
insert through one of the holes located at either end of the Pro II
fence. Loosely thread on the
1 ⁄ 4 -20 rectangular nut and slide the
extender bar into the cavity in the fence, capturing the rectangular nut
in the T-slot located on the extender bar. The scale on the extender
bar should be face up. Slide the extender bar until only about 1" of
the bar remains exposed and tighten the fastener, Fig. 2.
Place a 1 ⁄ 4 " washer and a 1 ⁄ 8 " thick nylon washer on the 1 ⁄ 4 -20 x 2"
socket head screw and insert through the extruded hole located on
the extender bar stop and loosely thread on the
1 ⁄ 4 -20 rectangular
nut. Slide the nut into the T-slot located on the front of the extender
bar. Slide the extender bar stop until the flat side of the stop contacts
the end of the Pro II fence. Tighten the fastener, then slide the scale
to read zero at the end of the fence extrusion, Fig. 3.
Caution: Never allow the opposite end of the extender
bar to protrude into the cut area.
Pro II
Fence
Rectangular
nuts captured
in T-slot
Steel fence
mounting bracket
1 / 4 -20 x 1 / 2 " socket
head screw with washer
Rectangular
nut captured
in T-slot
Extender
bar
1 / 4 -20 x 3 / 8 "
socket head
screw with
washer
1"
Slide scale to
read zero here
Extender
bar stop
1 / 8 " thick
nylon
washer
1 / 4 " washer
1 / 4 -20 x 2" socket
head screw