INCRA TS-LS Table Saw Fence - Manual (Page 6)

Attach the InCRA LS Positioner Base
to base support panel and loosely
attach remaining base clamp
Open the LS Mounting Hardware Pack B-04. Place #10
washers on each of the (8) #10-32 x
3 / 8 ” Phillips pan head
screws. Insert the screws through each of the (8) holes on the
red sub-base on your INCRA LS Positioner Base and loosely
thread a #10-32 hex nut onto each screw. Slide the hex nuts
on all (8) screws into the T-slots on the base support panel.
See Fig. 12 and Detail 12A.
Center the LS base on the support panel. (Edge of LS should
be about 11” from end of panel.) Use a square to align the
LS base at 90° to the panel and tighten
the four screws installed in the outermost
T-slots only. Do not tighten the remaining
(4) screws at this time. Slide the hex nuts
on the remaining base clamp into the
T-slots on the support panel.
4
Attach one base clamp to end of base
support panel
Open the Base Mount & Fence Glide Hardware Pack
B-03. Insert the (8) #10-32 x
7 / 16 ” Phillips flat head screws in
the countersunk holes of both base clamps and loosely thread
on the #10-32 hex nuts. Slide the hex nuts on one of the base
clamps into the (4) T-slots on the base panel, Fig. 11. Leave
about
3 / 8 ” between
the panel end and the
vertical surface on the
base clamp as shown in
Detail 11A and tighten
the screws. Set aside
the remaining fasteners
from the Base Mount & Fence Glide Hardware Pack B-03
for use in Steps 2 and 3 on page 8.
Remove
endcaps
from base
support panel
See Fig. 10 at right.
BASE MounT ASSEMBLY
Attach glide pads to
underside of base clamps
Peel the adhesive backing from the glide pad and adhere to
the base clamp as shown in Fig. 9. Repeat for remaining
base clamp.
Note: Do not attach glide pads until after main rail installation
has been completed. (See page 5, Figs. 4 and 5.)
1
2
FIG. 9
Adhere glide pad to
underside of base clamp
Adhesive
backed glide pad
Base clamp
FIG. 11
Attach one base
clamp to end of
base support panel
LS Positioner Base
Base support panel
Tighten outside (4) fasteners only at this time
Complete the base mount assembly detailed below before
adding fillers (table board, router tables) between the
rails.
Note: The base support panel used in the base mount
assembly is designed for use with table saws having a front to back measurement of up to 28”. If your table saw
measures greater than 28”, a custom cut support panel is
available. For details, e-mail us at customerservice@
incra.com or call us at 972-242-9975.
Endcap
FIG. 10
Base
clamp
FIG. 12
Attach LS to base
support panel
6 INCRA Woodworking Tools & Precision Rules
#10– 32 x 7 ⁄ 16 ”
Phillips flat head screw
#10-32
hex nuts
Base support
panel
3
Hex nuts for screws
captured in T-slots on
base support panel
Hex nuts
captured in
T-slots
Base support panel
3 ⁄ 8 ”
Base clamp
Detail 12A
Base support
panel
Base clamp
Base support
panel
Machinist square
#10– 32 x 3 ⁄ 8 ” Phillips pan
head screws with washers
11”
Detail 11A