Induro GH Gimbal Head - Manual

GH-SERIES GIMBAL HEAD
OPERATING INSTRUCTIONS
Thank you for making Induro your choice for
professional photographic gear. Your Induro gear
is manufactured to provide years of dependable
service. In order to obtain optimum satisfaction
and performance we suggest that you carefully
read these instructions and provide them to
anyone who may also use your Induro gear.
OPERATION (FIGURE 4)
The GH-Series Gimbal Heads are
professional devices and once adjusted for
typical operation only require two controls.
Slightly loosen both the Tilt Knob and Pan
Knob. Then aim the camera at the subject
and tighten both Knobs to lock.
If you’re photographing and following action,
you may keep both Knobs loose and take
advantage of the stability offered by the
Gimbal Head. Lock the Knobs when you
are finished or are not firmly holding the
Camera/Lens.
FOR OPTIMUM RESULTS: Adjust the balance
and Camera/Lens positioning with the weight
capacity, temperature and conditions under
which the Gimbal Head will be used.
NOTE: Do not over tighten any Locking
Knobs or try to move the Camera/Lens once
tightened as this could damage the Gimbal
Head locking mechanism.
USER NOTICE
c Do not exceed the maximum specified load
capacity (see specifications on the package
label or visit www.Induro.com).
c Always ensure that all Ballhead locks are
tightly engaged before mounting any gear.
c Do not use any Ballhead below
temperatures of −4°F or above +158°F
(−20°C / +70°C).
c Always clean and dry any Ballhead after
it has been exposed to wet, dusty, sandy
or salty conditions. Your Ballhead is not
recommended for use in salt water. If
required, clean Ballhead using a mild soap
solution applied with a soft cloth, rinse
with fresh water and dry with soft towel.
Remove any dust, dirt or sand from all
locks and all moving parts.
c Do not leave any Ballhead in the sun
for prolonged periods and avoid high
temperature exposure.
c Avoid leaving any Tripod or Monopod
unattended in areas where people could
trip over the gear and get hurt.
c Remove camera, lens, and all gear from
any Tripod or Monopod when transporting.
c For your safety, don’t let your Induro
gear come in contact with any electrical
power source.
Specifications and design are subject to change without notice.
All tradenames, logos, and brand references are the respective trademarks of their owners.
IN
D
U
R
O
C
am
er
a
Su
pp
or
t
G
ea
r
|
7
5
Vi
rg
in
ia
R
oa
d,
N
or
th
W
hi
te
P
la
in
s,
N
Y
10
60
3
|
T
9
14-
34
7-
33
00
|
F
9
14-
34
7-
33
09
|
in
fo
@
in
du
ro
ge
ar
.c
om
|
in
dur
og
ea
r.
co
m