INFICON Sensistor ISH2000 HySpeed Hydrogen Leak Detector User Manual
Hydrogen leak detector sensistor ish2000 hyspeed, Operating instructions
Advertising
Table of contents
Document Outline
- Welcome to Sensistor ISH2000 HySpeed
- Contents
- 1 User information
- 2 Description of equipment
- 3 Controls and connections
- 4 Precautions
- 5 Working principle
- 6 Operating the detector
- 7 Calibrate the leak detector
- 8 Reference section
- 8.1 Menu system
- 8.2 Engineering format
- 8.3 Change Test Mode
- 8.4 Calibration
- Calibrate
- Calibration intervals
- Sensitivity too low for reject level
- High signal! Check reference!
- Sensor condition indicator
- Calibration messages
- Reference Value
- Reference Unit
- Calibration Time
- Minimum calibration time
- Password protected calibration
- 8.5 Detection Mode Settings
- 8.6 Analysis mode
- 8.7 APC Settings
- 8.8 Display Settings
- 8.9 General settings
- 8.10 Service Settings
- 8.11 Combined Mode
- 8.12 Probe
- 8.13 Probe Control Port
- 8.14 Printer port
- Connector pin configuration
- Selectable printer types
- Table 8-5. Communication specifications.
- The detector can print the following information:
- 1 Date and Time for Power on of detector.
- 2 Time of print.
- 3 Value of all gas signals above the Reject Level.
- 4 Test result: “Accept” or “Reject”.
- 5 Value of signal.
- 6 Result of calibration: “OK” or “Calibration Not saved”, Date and Time, Parameter settings.
- Table 8-6. Probe type determines information printed.
- Table 8-7. Communication specifications.
- Table 8-8. The character indicating the result of the test is one of the following.
- Table 8-9. Communication specifications.
- RS232 serial communication
- APC driver installation
- 8.15 Sensistor ISH2000 HySpeed installation
- 8.16 Default parameters
- 9 Trouble-shooting
- 10 Sensistor ISH2000 HySpeed specifications
- 11 Spare parts and accessories
- 12 Support by INFICON
- 13 Declaration of conformity