INFICON Explorer Portable Gas Chromatograph - Manual (Page 62)

Explorer Operator Manual
60
Instrument Status Description
PowerDn Lamp turned off due to pressure fault
Over Range Signal was over range on the last run.
Tuning The UV lamp is being started
Wait Displayed at the delay time during
auto-cycling
Fault: Log Full Datalogger is full
Fault: Low Batt Battery condition is low
Fault: Lamp Lamp intensity failure
Fault: Oven Not Ready Oven not within +/- 1° of the set point
Fault: Pressure Carrier pressure is low
Fault: Calibration Bad calibration run