INFICON SQM-242 Thin Film Deposition Controller Card Operating Manual - Manual (Page 34)

3 - 6
IP
N 07
4-
54
9-
P1
A
SQM-242 Operating Manual
Input Reading . . . . . . . . . . . . . . . . . Displays the measured value of the selected
input. The units of the input reading are
determined by the type of measurement
(rate, thickness, power, or voltage) selected
for the recorder output.
Output Reading . . . . . . . . . . . . . . . The output voltage currently supplied to the
recorder by the recorder output.
3.5 File Menu
Open . . . . . . . . . . . . . . . . . . . . . . . . Selects a setup (.DAT) file to be used for thin
film deposition.
Save As . . . . . . . . . . . . . . . . . . . . . . Saves the current setup to disk. It can
replace the information in the current file or
be saved under a different name. Multiple
setups can be saved as different files. This is
convenient for storing different
configurations, materials, rates, etcetera.
Exit. . . . . . . . . . . . . . . . . . . . . . . . . . Exits the SQM-242 program. Before closing
the program, you are prompted to save
changes. Select Yes to overwrite the current
setup (.DAT) file, no to abandon any
changes, or Cancel to return to the program.
3.6 View Menu
3.6.1 View Menu: Readings
Selecting the View menu, then Readings, displays a grid of all sensor and analog
inputs. It also provides a convenient place to view the overall input/output
configuration of your system. See
Figure 3-4 .
Figure 3-4 Input Readings
Unlike the main dialog box, which may show the average of several sensors
assigned to an output, this dialog box displays raw input readings. The size of the
grid is adjusted to display only the components installed in your system.