BEA 10T300PB - Manual

Page 1 of 2
75.0092 V4 Jan 2004 [Rev. 1/26/2004]
PRODUCT
DESCRIPTION
COMPONENT ID
SAFETY
PRECAUTIONS
BEA’s line of pushplate hardware is expanded by its line of surface and flush mount pushplate boxes. These
boxes are made of durable ABS plastic and are made to securely mount a pushplate and a variety of
optional transmitters to activate an automatic door. Many of the boxes have an optional weather ring to give
even more weather protection to the switch. They are also designed to attractively recess the pushplate in
the housing to and to minimize vandalism from prying up the pushplate.
PUSHPLATE SIZE PUSHPLATE
SERIES SURFACE MOUNT BOX FLUSH MOUNT BOX WEATHER RING
(Optional)
Jamb (4” hole spacing) 10PBJx 10BOXJAMBSM 10BOXJAMBFM N/A
Jamb (3 ¼” hole spacing) 10PBJSx 10BOXJAMBST N/A N/A
4 ½” Square 10PBS45x 10BOX45SQSM N/A N/A
4 ¾” Square 10PBSx 10BOX475SQSM 10BOX475SQFM 10WRSQ475
4 ½” Round 10PBR45x 10BOX45RNDSM 10BOX45RNDFM 10WRRND45
6” Round 10PBRx 10BOX6RNDSM 10BOX6RNDFM 10WRRND6
4”
JAMB
3 ¼ ”
JAMB
4 ½”
SQUARE
4 ¾ ”
SQUARE
4 ½ ”
ROUND
6”
ROUND
4”
3 ¼”
•
Shut off all power going to the header before attempting any wiring procedures.
•
Maintain a clean & safe environment when working in public areas.
• Constantly be aware of pedestrian traffic around the door area.
• Always stop pedestrian traffic through the doorway when performing tests that may result in unexpected
reactions by the door.
•
Always check placement of all wiring before powering up to insure that moving door parts will not catch
any wires and cause damage to equipment.
•
Ensure compliance with all applicable safety standards (i.e. A NSI A156.10) upon completion of
installation.
USERS GUIDE
PUSHPLATE MOUNTING BOXES
We open up New Horizons
9V Battery Clip
(1 per box, not used
on jamb sized boxes)
Transmitter Mounting Pin
(6 per box, not used on jamb
sized boxes)
Pushplate Mounting Box
(4 ½” Round Surface Mount shown)