INFICON XTM/2 Thin Film Deposition Monitor - Manual (Page 57)

3 - 5
IP
N 07
4-
18
6S
XTM/2 Operating Manual
5 Coat the stripped portion of the wire(s) with the flux and insert into the solder
cup of the contact until the conductor is bottomed in the cavity.
6 Heat the solder cup with the soldering iron and allow the solder to flow into
the cup until the cavity is filled but not over filled.
7 Continue soldering wires until all terminations are complete.
8 Clean the soldered connections with a suitable alcohol/water rinse to
remove flux and solder residue.
Figure 3-2 Solder Cup Connector
Wire Strip
Length 1/4" (6.4 mm)
Contacts
Solder Cup
Grounding
Indents
(Plug Only)