IPitomy IP550 User Manual Ver.1 - Manual (Page 7)

IPitomy Confidential 2
Chapter Chapter Chapter Chapter 2 2 2 2
Installation Installation Installation Installation
This Chapter covers the physical installation of the IP Phone.
Requirements
• Network cables. Use standard 10/100BaseT network (UTP) cables with RJ45 connectors.
• For Internet Access, an Internet Access account from ISPs, and either a DSL or Cable
modem is required.
Procedure
1. Connect the Handset
Connect the handset to the jack on the left-hand side of the IP phone.
2. Connect to the Network
Use standard Ethernet cable to connect the network to the "LAN" port on the IP Phone.
Connect your PC to the "PC" port on the back of the IP Phone, as shown in the diagram
below.
3. Power Up
Connect the supplied power adapter to the IP Phone and power up.
Use only the power adapter provided. Using a different one may cause hardware damage.
Figure 1: Connecting IP Phone and Your PC
2 2 2 2