Aastra Telecom 480i SIP (Release 1.4) - Manual (Page 29)

480i IP Phone User Guide 23
Handling Cal
ls
Note: To disable call forwarding in the
Aastra Web UI, set the mode to
OFF and remove the phone num-
ber in the "Number" field.
3. In the "Number" field, enter the
call forward number for which
you want your calls to be call
forwarded.
4. In the "Number of Rings" field,
enter the number of rings you
want to set before the call is
forwarded. Valid values are 1 to
9.
5. Click to save the Call
Forward settings. The changes
are dynamic and are immedi-
ately applied to the phone.
For Per-Line Call Forward Settings
(not applicable to the 9112i):
1. Select a line to set Call Forward-
ing on.
2. In the "Mode" field, select the
mode you want to set on this
line.
Note: To disable call forwarding in the
Aastra Web UI, set the mode to
OFF and remove the phone num-
ber in the "Forward Number"
field.
Note: To force a line to use the global
settings, set the "Mode" field to
Global.
3. In the "Forward Number" field,
enter the call forward number
for which you want your calls on
this line to be call forwarded.
4. In the "Number of Rings" field,
select the number of rings on
the line before the call is for-
warded. Valid values are 1 to 9.
5. Click to save the Call
Forward settings. The changes
are dynamic and are immedi-
ately applied to the phone.
Park Calls/Pick Up Parked
Calls
The 480i phone has a park and
pickup call feature that allows you
to park a call and pickup a call
when required. There are two ways
you can configure this feature:
• Using a static configuration
• Using a programmable
configuration (configure a soft-
key)
Note: The IP phones accept both meth-
ods of configuration. However, to
avoid redundancy, Aastra Tele-
com recommends you configure
either a static configuration or a
programmable configuration.
The IP phones support the Park/
Pickup feature on the Asterisk,
BroadWorks, Sylantro, and ININ
PBX servers.
The following paragraphs describe
the park and pickup methods of
configuration on the IP phones.
Park/Pickup Static Configuration
You can configure a static
configuration for parking and
picking up a call using the Aastra
Web UI at Basic Settings->
Preferences. By entering the
appropriate value in the "Park
Call" and "Pickup Parked Call"
fields, you tell the phone where to
park a live call and where to
pickup the parked call.
On the IP phone UI, the static
configuration method displays the
following:
• When a call comes in, and you
pickup the handset, the default
label of "Park" displays on the
Phone UI.
• After pressing the "Park" soft-
key to park the call, the default
label of "Pickup" displays on the
phone UI.