Aastra Telecom 480i SIP (Release 1.4) - Manual (Page 32)

26 480i IP Phone User Guide
Handling Cal
ls
Note: For values to enter in this field,
see the table "Park/Pickup Call
Server Configuration Values" on
page 24 .
6. In the "Line" field, select a line
for which to apply the Park con-
figuration.
7. Pick a softkey to configure for
Picking up a call.
8. In the "Label" field, enter a label
for the Pickup softkey.
9. In the "Value" field, enter the
approriate value based on the
server in your network.
Note: For values to enter in this field,
see the table "Park/Pickup Call
Server Configuration Values" on
page 24 .
10.Click to save your
changes.
11.Click on Operation->Reset.
12.In the "Restart Phone" field
click to restart the IP
phone.
Using the Park Call/Pickup
Parked Call Feature
Use the following procedure on the
IP phones to park a call and pick
up a parked call.
Park a Call
1. While on a live call, press the
"Park" softkey.
2. Perform the following for your
specific server:
If the call is parked successfully,
the response is either a greeting
voice confirming that the call
was parked, or a hang up
occurs. The parked call party
will get music on hold.
3. If the call fails, you can pick up
the call (using the next proce-
dure) and press the "Park" soft-
key again to retry step 2.
Pickup a Parked Call
1. Pick up the handset on the
phone.
2. Enter the extension number
where the call was parked.
3. Press the "Pickup" softkey.
If the call pick up is successful,
you are connected with the
parked call.
For Asterisk Server
- Server announces the extension
number where the call has been
parked. Once the call is parked,
press the y key to complete
parking.
For BroadWorks Server
- After you hear the greeting from
the CallPark server, enter the
extension where you want to park
the call.
For Sylnatro Server
- Enter the extension number where
you want to park the call, followed
by "#" key.
For ININ Server
- Enter the extension number where
you want to park the call, followed
by "#" key.