JULABO KRC 180 Refrigerators for chemicals - Manual (Page 14)

Cleaning / repairing the unit
14
8. Cleaning / repairing the unit
Caution :
Always turn off the unit and disconnect the mains cable from the power source
before performing any service or maintenance procedures.
Cleaning of the opened unit may only be done by authorised and qualitfied
personnel.
Prevent humidity from entering into the electronik module and the control unit.
In case of suspected leaks in the refrigerant cycle defect units may not be
transported by air.
Clean the interior of the refrigerator and the outside of the unit using a wet cloth
and low surface tension water.
The circulator is designed for continuous operation under normal conditions.
Periodic maintenance is not required.
Repairs
Before asking for a service technician or returning a JULABO instrument for
repair, please contact an authorized JULABO service station.
When returning the unit:
Clean the unit in order to avoid any harm to the service personnel.
When returning a unit, take care of careful and adequate packing.
Attach a short fault description.
During transport the unit has to stand upright. Mark the packing correspondingly.
In case of suspected leaks in the refrigerant cycle defect units may not be
transported by air.
JULABO is not responsible for damages that might occur from insufficient
packing.
JULABO reserves the right to carry out technical modifications with repairs for
providing improved performance of a unit.