BIONAIRE BQH308C-U - Manual (Page 2)

HEATER SAFETY
PLEASE READ AND SAVE
THESE IMPORTANT
SAFEGUARDS
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions
should always be followed to reduce the risk of fire, electric
shock, and injury to persons, including the following:
1. Read all instructions before using the appliance.
2. To avoid fire or shock hazard, plug the appliance
directly into a 120V AC electrical outlet.
3. The heater is hot when in use. To avoid burns, DO
NOT let bare skin touch hot surfaces. If provided, use
handles when moving this heater. Keep combustible
materials, such as furniture, pillows, bedding, papers,
clothes, and curtains at least 3 ft (0.9 m) from the front
of the heater and keep them away from the sides and
rear.
4. DO NOT run cord under carpeting. DO NOT cover
cord with throw rugs, runners, or the like. Arrange cord
away from traffic area and where it will not be tripped
over.
5. This heater is not intended for use in bathrooms,
laundry areas and similar indoor locations. NEVER
locate heater where it may fall into a bathtub or other
water container.
6. Extreme caution is necessary when any heater is used
by, or near children or invalids, and whenever the
heater is left operating and unattended.
7. Always unplug the heater when not in use.
8. When unplugging, be sure to pull by the plug and not
the cord.
9. DO NOT insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an
electric shock or fire, or damage the heater.
10. DO NOT operate heater with a damaged cord or plug,
or after the heater malfunctions, or has been damaged
in any manner. Return appliance to manufacturer for
examination, electrical or mechanical adjustment, or
repair.
11. A heater has hot and arcing or sparking parts inside.
DO NOT use it in areas where gasoline, paint, or
flammable liquids are used or stored.
12. Use appliance only for intended household use as
described in this manual. Any other use not
recommended by the manufacturer may cause fire,
electric shock, or injury to persons. The use of
attachments not recommended or sold by the
manufacturer may cause hazards.
13. DO NOT use outdoors.
14. To prevent a possible fire, DO NOT block air intakes or
exhaust in any manner. DO NOT use on soft surfaces,
like a bed, where openings may become blocked.
15. To disconnect heater, turn controls to OFF, then
remove plug from outlet.
16. Avoid the use of an extension cord because the
extension cord may overheat and cause a risk of fire.
However, if you have to use an extension cord, the
cord shall be No. 14 AWG minimum size and rated not
less than 1875 watts.
17. If the heater will not operate, see specific instructions
on Auto Safety Shut-off.
18. DO NOT attempt to repair or adjust any electrical or
mechanical functions on this unit. Doing so will void
your warranty. The inside of the unit contains no user
serviceable parts. All servicing should be performed by
qualified personnel only.
19. DISCONTINUE USE IF PLUG OR OUTLET IS HOT.
RECOMMEND OUTLET BE REPLACED IF PLUG OR
OUTLET IS HOT TO TOUCH.
PLEASE READ AND SAVE
THESE IMPORTANT
SAFETY INSTRUCTIONS
NOTE: When the heater is turned on you may notice
vibration/noise coming from the grill and the interior
quartz tubes. PLEASE NOTE THAT THIS IS NORMAL
AND SAFE OPERATION. Once the quartz heating
element has warmed up, the vibration/noise will go
away.
CONSUMER SAFETY INFORMATION
THIS PRODUCT IS EQUIPPED WITH A
POLARIZED AC PLUG (a plug having
one blade wider than the other). This
plug will fit into the power outlet only one
way. If the plug does not fit fully into the
outlet, reverse the plug. If it still does not
fit, contact qualified personnel to install the proper outlet.
DO NOT DEFEAT THE SAFETY PURPOSE OF THIS
POLARIZED PLUG IN ANY WAY.
TECHNICAL SPECIFICATIONS
•
Wattage: 1500W (+5% -15%)
• Working Voltage: 120V AC/60 Hz
AUTO SAFETY SHUT-OFF INSTANT TIP OVER
PROTECTION
This heater is equipped with a patented, technologically-
advanced safety system that requires the user to reset the
heater if there is a potential overheat situation. When a
potential overheat temperature is reached, the system will
automatically shut the heater off. It can only resume
operation when the user resets the unit. The reset button is
located at the back of the heat.
Tip-Over Shut-Off:
When the unit is accidentally knocked over, it will instantly
shut off. To reset, simply place the heater in an upright
position. Press the MODE button and it will operate nor-
mally.
MAXFLOW TM FAN SYSTEM
The patented MaxFlow TM Fan system incorporates a top
mounted fan and internal shroud to provide maximum heat
dispersion. The MaxFlow
TM Fan system is activated by
using the Heat Control Knob. It delivers a combination of
instant, penetrating warmth in the immediate area, as well
as forcing the heat out for entire room coverage.
SETTING THE THERMOSTAT
1. You need to set thermostat on HI ( II ) to start heater
(See Figure 1). Allow heater to operate and warm up the
room.
2. When the desired temperature/comfort level is
reached, lower the thermostat setting until the
fan/heater stops operating.
3. The control will now automatically turn the heater ON
and OFF to maintain the preset temperature level.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, you need to raise the thermostat setting.
PRE-OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please save
the carton for off-season storage.
2. Make sure the unit is in the OFF ( O ) position before
plugging the heater into the outlet.
NOTE: This unit is for FLOOR USE ONLY.
3. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet.
NOTE: Discontinue use if plug or outlet is hot.
NOTE: Recommend outlet be replaced if plug or outlet is
hot to touch.
OPERATING INSTRUCTIONS
1. For heater operation, please set the Thermostat all the
way to HI. (See Figure 1)
2. Turn the Mode to desired heat setting ( LO ( I ) for
750W or HI ( II ) for 1500W ).
3. The Caution Light will remain lit during operation.
CLEANING/MAINTENANCE
During Season Care:
1. Always unplug the heater before cleaning.
2. Clean the unit with a soft cloth moistened with a mild
soap solution.
3. NEVER use abrasive or flammable solvents to clean the
unit.
4. After cleaning, be sure to completely dry the unit with a
cloth or towel.
After Season Care:
1. Store heater in a cool, dry location.
2. The manufacturer recommends that you store the unit
in its original carton.
☛
TIP: Over time, dust may accumulate on the front grills.
This can be removed by wiping the unit with a damp
cloth. Always unplug unit and allow to cool prior to
cleaning.
Lo
Hi
Lo
Hi
Lo
Hi
Lo
Hi
I
II
I
II
Figure 1
Thermostat
Caution Light
Mode Control
Heat Control Display
BQH308C-U_07EM1.qxd 5/11/07 8:34 Page 2