Kargo Master Econo Truck Rack – With Camper Shell (30060) - Manual

( HIGH POSITION )
D
STEP 1-
NOTE: If it is not possible to locate a second hole close to the front
leg because of the stake pocket, use our stake pocket T bolt mount
kit (#31560) purchased separately.
CHECK TWICE - DRILL ONCE!
Monday- Friday 8:00 A.M. to 4:30 P.M. (PACIFIC )
®
2 BAR ECONO CAMPER SHELL RACK
Assembly Instructions
1-800-343-7486
For TECHNICAL SUPPORT Call:
C
(8 ea.)
3/8" Lock Nut
B
3/8" Flat Washer
(8 ea.)
D
(8 ea.)
3/8" x 1/2"
Allen Head
Set Screw
#30060
A
(8 ea.)
3/8" x 1 3/4"
Hex Bolt
• To install the rear ECONO TRUCK RACK on your truck bed, repeat the above. Before drilling the mounting plate, make sure that the plate
dose not overhang or interfere with the tail gate. Before inserting the Caps, make sure that the height setting in the rear matches the height
setting in the front.
STEP 3- Your rack can be set high or low by flipping the CROSSBAR SUPPORT, (as shown) Determine
which is best for your vehicle and your cargo. For bowed canoes, we recommend the high position.
STEP 5- Insert the CROSSBAR into the CROSSBAR SUPPORTS and set the entire
assembly on top of the legs. Cut CROSSBAR to shorten length, IF NEEDED, for the width
of a mini-truck bed. CENTER THE CROSSBAR LEFT TO RIGHT, and secure with set
screws. Secure the CROSSBAR SUPPORT UPRIGHT to each leg with set screws.
BOLT KIT
THAT'S IT! You're ready to load and go! Tighten all bolts and....
Be sure FRONT MOUNTING PLATES are as far
forward towards the cab as possible. Find the pre-drilled hole
in the footplate that is furthest from the leg and drill
3/8”
hole
through truck’s bed rail. You must drill a second bolt hole through
both the footplate and the truck’s bed rail. Locate this second hole
as close as possible to the front leg, but making sure you can
access the end of the bolt underneath the truck’s bed rail as
necessary to put on the washer and nut. Attach the footplate to
the truck using bolts A, washers B and nuts C .
DO NOT OVER TIGHTEN ON DOUBLE WALL BED CONSTRUCTION, AS THIS MAY DEFORM THE SHEET METAL OF THE PICKUP BED!
( LOW POSITION )
Crossbar Support Upright
STEP 4- Plug the TOP of the CROSSBAR SUPPORT UPRIGHT with caps provided.
P (8 ea.)
1/2" x 1"
Hex Bolt
O
(5 ea.)
1/2" Lock Washer
H
(15 ea.)
1/2" SAE Flat Washer
Leg
Mount Plate
INSIDE
BED W
ALL
B
H
O
P
C
A
Outside of
Truck Bed
P
O
H
CAMPER SHELL STEP 2- Replace camper shell with appropriate weather stripping . Attach legs
loosely to mounting plates with bolts P, lock washers O, and flat washers H.