Kargo Master Transit Partition (406TH) - Manual (Page 5)

Step 3
On the driver’s side install the 2 M6 U-nuts in the “B” pillar as shown below (Some of the Van body parts are excluded
for clarity). If your van has the factory interior panels (it’s an option) loosen the 2 bolts that hold the panel to the ”B”
pillar and slide the wing behind the bracket. Next use the 5/16”x1” self tapping screws on the driver’s side wing panel,
one in the top hole and one in the 3
rd from the bottom and use the M6x25 bolt on the passenger side wing panel. Now
you can bolt the upper bracket in place using the 5/16”x1” self tapping screws and ¼”x3/4” Carriage bolts. Put a straight
edge along the bottom to keep it straight and use the 5/16”x1 ¼” self tapping screws into the floor. There are 5/16”x 1”
self tapping screws for mounting the “Top Panel” if wanted, but NOT necessary. You can now re-install the factory “D”
rings. Be sure to go back and tighten all the hardware at this point.
5