Kinze 3660 Lift and Rotate Planter Rev. 7/14 - Manual (Page 40)

M0217-01 Model 3660
2-28 Rev. 7/11
TM
Machine Operation
AUXILIARY HYDRAULIC OPTION
A customer-supplied auxiliary hydraulic option may be added to provide 10 gpm of oil flow at rear of planter. It is
designed for powering bulk seed handling equipment when planter is not in motion and is controlled by the same
tractor hydraulic control as the seed rate hydraulic drive.
WARNING
Pressurized hydraulic fluid can penetrate body tissue and result in
death, serious infection, or other injuries. Fluid injected under skin
must be IMMEDIATELY removed by a surgeon familiar with this
type of injury. Make sure connections are tight and hoses and
fittings are not damaged before applying system pressure. Leaks
can be invisible. Keep away from suspected leaks. Relieve pressure
before searching for leaks or performing any system maintenance.
Customer-supplied hoses, fittings, and hydraulic outlets are added to ports AUX1 and AUX2 on lower valve block on
back side of planter. Refer to “Hydraulic System Schematics” in the Lubrication and Maintenance section for additional
information.
NOTICE
Make sure MASTER switch is OFF on Kinze Vision or Cobalt display
and planter is not in motion when using auxiliary hydraulic circuit.
Lower valve block
AUX2
AUX1