Kinze Grain Carts Rev. 7/14 - Manual (Page 59)

TM
Grain Cart M0238-01
5/12 3-23
Lubrication and Maintenance
NOTICE
Check track alignment daily to prevent damage and ensure maximum
track life.
Track centering lugs should run centered between end wheel segments as lugs enter end wheels when tracks are
rotated. Misalignment may cause rubbing between track guide lugs and end wheel segments.
NOTE: Extending sidebar (turning 1" adjusting bolt clockwise) closest to end wheel showing evidence of
misalignment or retracting sidebar (turning the 1" adjusting bolt counterclockwise) on end wheel on opposite
side will move centering lugs away from end wheel.
1. Loosen four ¾" attachment cap screws on each sidebar and extend or retract sidebar(s) until proper alignment is
obtained.
2. Retighten four ¾" cap screws on each sidebar.
3. Torque hardware to 220 ft-lb (298 N-m). Tighten inside and outside sidebars equally.
TRACK ALIGNMENT
Track alignment
¾ " Cap Screws