Kisan Electronics VL-20 - Manual (Page 11)

Page- 9
VL-10 INSTALLATION:
vectraLIGHT (VL-10) model is a plug-n-
play turn signal and stop-light LED array.
Simply plug each right and left side unit
in to the signalMinder RJ-11 ports.
There is a label to indicate the right and
left side array. Red LEDs face the rear.
In turn signal mode, the (5) front facing
Amber LEDs and the (5) rear facing Red
LEDs flash sequentially. With the brakes
applied the rear facing Red LEDs stay on
with full brightness.
The intensity of the Run-Light mode is also adjustable – as selected from
the signalMinder.
Before you mount the units, consider how you will route the cable.
Routing the cable to make connections will depend on whether the side-
view mirrors are stalk mounted or attached to the fairing.
„
If stalk mounted, use wire-ties to
secure the cable - allowing for
appropriate slack so that the mirror
can be moved freely.
„
If attached to the fairing, locate an
opening through which the RJ-11 4-
pin plug can slide in.
„
Avoid sharp metal edges, hot
exhaust pipes and high voltage spark
plug wires, as you route the cable
towards the signalMinder.