Koolance EXT-440CU-R - Manual (Page 7)

6 7 User Manual
Positioning the Cooling System
The cooling system is designed to operate in various
locations, but it must run upright. Reservoir air filtration is
not possible in all orientations.
Depending on the individual system, placing the cooling
unit 3-6 feet (1-2 meters) away is an acceptable distance
for most installations. Check operating temperatures before
placing in a more remote location.
Extra tubing can be purchased from
Koolance.com or your local reseller.
Installation
Rubber pads are included to place on the bottom feet of the cooling system. If
you are frequently transporting your cooling unit, optional “Attachment Straps” are
available which thread through the metal foot loops below the unit.
Rubber Foot Pad
External Nozzles & Power Cable
Cut tubing into two segments. You
will need to connect each to the rear
nozzles.
Each hose connection will use a threaded compression
ring or hose clamp to keep it secure. Be sure to thread
the compression ring or hose clamp onto the hose
before attaching it.
Once the hoses are connected, plug the
external power cable into the cooling
system.
Attachment Straps
Squeeze the tube while pushing it firmly
over the nozzle. Tubing should completely
cover the nozzle.
Tighten the connection by sliding the
compression fitting down over the nozzle and
screwing securely. For hose barbs, use pliers
to move it into the proper position.
Install the nozzles you purchased for your cooling
system. It’s recommended to hand-tighten all
fittings to avoid damaging the cooling unit.