Koolance MVR-40 - Manual

Tighten both swinging mounting
arms to the top of the MVR
water block with the larger screws. The arms
should loop around the nearest mounting post.
The swinging arms are highly adjustable. Make
sure they are not positioned in a way that will
interfere with the water block’s nozzles.
NOTE: The motherboard should be removed from the chassis in order to install
this cooling device. This guide assumes the proper MVR-PLT Heat Transfer
Plate(s) have already been purchased for your motherboard. For assistance in
determining which MVR-PLT you might require, please visit: http://www.koolance.
com/product_wizard/mvr_help.php
CAUTION: Removal of the original heat sink may void your manufac-
turer’s hardware warranty. Please consult the manufacturer if unsure,
and keep all original parts in case of a return/RMA.
!
MVR-40, MVR-100 Installation Guide v 1.0
1 2
The mainboard’s stock VReg/MOSFET heat
sink(s) must be removed in order to install
an MVR water block. If these heat sinks are
also connected to the northbridge (and/or
southbridge) with heat pipes, the entire cooling
assembly should be removed.
Any newly exposed areas must also be liquid
cooled to avoid overheating. Please see the
Koolance website (www.koolance.com) for a
complete list of motherboard water blocks.
To remove the stock heat sinks, locate the locking
pins and squeeze each together beneath the
motherboard. (Some boards may use screws.) This will free
the pins to be pulled out above the motherboard.
VReg #2
VReg #1
Northbridge
Southbridge
Once loose, remove the stock heat sink / heat
pipe assembly.
Spread thermal compound on the
bottom (narrower) side of the MVR
water block. It should be applied
thinly and evenly using the included
paste packet, or a piece of thick
paper (such as a business card).
Place the MVR-PLT heat transfer plate onto the bottom
side of the water block. The plate’s beveled screw holes
should face away from the block:
Tighten the MVR-PLT heat transfer plate to the
MVR water block using the 2 included fl at-topped screws.
Remove the clear protective film from
the white side of the MVR-PLT plate’s
thermal pad.
Place the thermal pad onto the bottom of the MVR-PLT heat
transfer plate.
There should be at least two mounting
holes in the motherboard at the ends
of each VReg area. Insert the smallest
screws through a plastic washer and up
through the motherboard. Place a second
washer on each screw above the board.
3 4
Tighten a threaded metal mounting post onto
each screw.
Beveled screw holes
If you are using longer MVR heat transfer plates,
additional threaded holes are provided at each end.
Screw the metal hexagonal stand-offs into these
holes on the same side as the water block.
The swinging mounting arms will attach to the
hexagonal stand-offs instead of to the MVR water
block directly.
Lastly, place the thumb nuts onto both
mounting posts and tighten.