Koolance TMS-100K - Manual (Page 2)

Koolance TMS-100K Installation Guide
v1.00
2
Software Installation
After connecting the TMS board (except the USB cable) and
mounting the card within the computer case, insert the CD-ROM
to launch the installation program.
Select the features you would like to install. The PL-2303 Drivers
will be necessary for the TMS software to communicate with the
hardware card.
NOTE: If you are using Windows XP 64-bit version, skip the
PL-2303 Drivers installation here. The necessary “.INF” fi les are
located on the TMS CD-ROM under “/xp64/”.
Once all software and drivers have been installed, launch the TMS program.
There will be no activity yet, and “Port Open error!” will display in the message
bar.
Now connect one USB cable to the TMS board. Either loop the external cable back to an available external port, or plug the
internal cable from the TMS board to the motherboard’s internal USB header (if available).
CAUTION: If using the internal cable, be sure the motherboard’s USB pinout is compatible with the TMS cable. Some motherboards may not take
this particular type of wire layout. Also be sure NOT to connect the TMS cable to a 1394 Firewire header, or hardware damage may result.
!
After a few seconds, the TMS program should fi nd the available USB port.
All available options in TMS will then be active.
If there are any alarms immediately sounding in TMS, the program will need
some confi guration (for example, the pump “disabled” if a PMP-400 is not
connected).
To learn how to operate the program, please see the help (?) button in TMS.