Koolance VID-205-L06 User Manual

Page 2

Advertising
background image

3

Remove the protective film from the
bottom of the chipset cooler and mount
it to the video card.

4

R e m o v e a l l h a r d w a r e n u t s ,
washers, and metal posts from
the Koolance black rear brace.
Then, insert it into the back side
of the video card.

This piece aligns with the same
4 mounting holes as the original
rear heat sink brace.

On front of the card, place plastic insulating
washers on each of the 4 brace mounting
screws.

Over each washer, screw-tighten a metal
post.

Finally, screw-tighten a mounting nut
fi rmly to each metal post.

NOTE: Video card RAM chips are not
perfectly fl at with one another. To make sure
your VID-200 is making the best contact
possible for your card, remove the cooler and
examine the distribution of thermal paste.

A missing or inadequate “spot” might be
corrected by further tightening a top mounting
nut (gradually), or applying more thermal
paste to the chip.

Advertising
This manual is related to the following products: