Koolance VID-387-R - Manual (Page 2)

3
Place the Koolance block over the video
card.
Koolance VID water blocks include redundant G1/4 threading on both sides. This
means the input/output nozzles can be placed on either side of the cooler.
Two G1/4 “caps” are included
with Koolance VID-series
coolers which can be placed
opposite the desired nozzle
locations.
Radeon HD 3970 Thermal Pad Areas
Thermal paste is only required on the main GPU. The
other areas will utilize the included heat transfer pads.
Spread thermal compound on the GPU thinly and evenly
using the included paste packet, or a piece of thick paper
(such as a business card). Thermal paste is not required
on the surrounding metal support frame.
2
Heat transfer pads have plastic fi lm on one or both sides that
must be removed before application.
Place the 4 heat transfer pads on each
additional area cooled by the Koolance liquid
block. This includes 3 rows of memory, and
one VReg area.
Apply a small amount of thermal paste to the junction between
the voltage regulator block and the main VID cooling block.
Attach the voltage regulator block to the main VID block using the included 3
large screws.
Main VID
Block
Voltage
Regulator
Block
Tighten each screw on the reverse side of the card. If the original mounting screws
do not fi t, use the Koolance-supplied screws and plastic insulating washers,
Koolance-Supplied Screw and
Insulating Washer
3
Place the Koolance block over the video
card.
Koolance VID water blocks include redundant G1/4 threading on both sides. This
means the input/output nozzles can be placed on either side of the cooler.
Two G1/4 “caps” are included
with Koolance VID-series
coolers which can be placed
opposite the desired nozzle
locations.
Radeon HD 3970 Thermal Pad Areas
Thermal paste is only required on the main GPU. The
other areas will utilize the included heat transfer pads.
Spread thermal compound on the GPU thinly and evenly
using the included paste packet, or a piece of thick paper
(such as a business card). Thermal paste is not required
on the surrounding metal support frame.
2
Heat transfer pads have plastic fi lm on one or both sides that
must be removed before application.
Place the 4 heat transfer pads on each
additional area cooled by the Koolance liquid
block. This includes 3 rows of memory, and
one VReg area.
Apply a small amount of thermal paste to the junction between
the voltage regulator block and the main VID cooling block.
Attach the voltage regulator block to the main VID block using the included 3
large screws.
Main VID
Block
Voltage
Regulator
Block
Tighten each screw on the reverse side of the card. If the original mounting screws
do not fi t, use the Koolance-supplied screws and plastic insulating washers,
Koolance-Supplied Screw and
Insulating Washer