Koolance VID-AR687 - Manual

All heat sink assembly screws should be removed. There are
multiple screws on the rear of the video card, and 2 more on
the L-bracket.
NOTE: The video card should be removed from the chassis in order to install this
cooling device. Most cards using the VID-series blocks are disassembled the same
way, although heat sink assemblies of any given model can vary.
CAUTION: Removal of the original heat sink or liquid cooling may void
your manufacturer’s hardware warranty. Please consult the manufac-
turer if unsure, and keep all original parts in case of a return/RMA.
!
VID-AR685, VID-AR687 Installation Guide v 1.0
1
HD 6850 (Above) and HD 6870 (Below) Disassembly Screws
Remove Bracket
Screws (both
models)
Tighten each screw on the reverse side of the card. If the
original video card screws do not fit, use the Koolance-
supplied screws and plastic insulating washers.
4
Socket plugs are included with the VID
coolers which must be placed opposite
the desired nozzle locations.
Connecting Multiple VID Coolers
When connecting multiple VID coolers, Koolance offers an optional direct-connect
nozzle. This minimizes liquid routing while avoiding potential conflicts with hardware
in between the video cards.
Optional Two-Three Slot (CNT-VDA34) and
One Slot (CNT-VDA2) Video Connectors
G 1/4 BSP inlet/outlet nozzles can be
screwed into the top or bottom side of the
cooler, as long as coolant flows from one half
to the other (left to right or right to left).
Koolance-Supplied Screw and
Insulating Washer
The thermal pad sheet should be cut into
pieces required for your video block contact
areas. Please use the diagram included with
your water block to determine the approximate sizes that
will be needed.
3
Place the Koolance block
onto the video card so the
mounting screws will align.
Gray thermal pads have plastic film on both sides that must
be removed before application. White/Pink thermal pads only
have plastic film on one side (white) that must be removed.
Do this after cutting the proper shapes.
2
Thermal paste is only required on the main GPU. The other
areas will utilize the included heat transfer pads.
Spread thermal compound on the GPU thinly and evenly
using the included paste packet, or a piece of thick paper
(such as a business card).
Different sets of heat transfer pads may be included. Each
set has a different thickness, and one should be chosen
that offers best contact with your video card.
Unplug the heat sink fan wire. Remove
all original thermal material, and wipe any
residual thermal paste from the main GPU
chipset.
With all screws removed, carefully remove
the primary heat sink and fan shroud. Original
thermal paste may present resistance during
removal.
For the HD 6850, remove the extra heat sink
underneath the top cover.
VID-AR685 (Left) and VID-AR687 (Right) Thermal Pad Locations
Basically, any area of the video card in contact
with the original heat sink will need new heat
transfer material. Place heat transfer pads on the
corresponding areas of the Koolance water block.