Koolance VID-NX480 - Manual

All heat sink assembly screws should be removed. There should
be 15-16 of these on the back of the video card. There are an
additional 2 screws on the rear L-bracket. Also check below stickers and pads.
NOTE: The video card should be removed from the chassis in order to install this
cooling device. Most cards using the VID-series blocks are disassembled the same
way, although heat sink assemblies of any given model can vary.
CAUTION: Removal of the original heat sink my void your manufac-
turer’s hardware warranty. Please consult the manufacturer if unsure,
and keep all original parts in case of a return/RMA.
!
VID-NX470, VID-NX480 Installation Guide v 1.0
1
GTX 480 Disassembly Screws (Top) and GTX 470 (Bottom)
4
Two G1/4 “plugs” are included
with the VID coolers which can be
placed opposite the desired nozzle
locations.
Connecting VID Coolers in SLI or CrossFire
When connecting multiple VID coolers in series, Koolance offers an optional direct-
connect nozzle. This minimizes liquid routing while avoiding potential conflicts with
hardware in between the video cards.
Optional Two-Three Slot (CNT-VDA34) and
One Slot (CNT-VDA2) Video Connectors
Koolance VID coolers include redundant
G1/4 threading on both sides. This means
the input/output nozzles can be placed on
either side of the cooler.
Using the Koolance-supplied screws and plastic insulating
washers, tighten each screw on the reverse side of the
card.
Koolance-Supplied Screw and
Insulating Washer
Thermal Paste Area
Gray thermal pads have plastic film on both sides that must
be removed before application. White/Pink thermal pads only
have plastic film on one side (white) that must be removed.
Do this after cutting the proper shapes.
The thermal pad sheet should be cut into
pieces required for your video block contact
areas. Please use the diagram included with
your water block to determine the approximate sizes that
will be needed.
2
Thermal paste is only required on the main GPU. The other
areas will utilize the included heat transfer pads.
Spread thermal compound on the GPU thinly and evenly
using the included paste packet, or a piece of thick paper
(such as a business card).
Two different sets of heat transfer pads are included. Each
set has a different thickness, and one should be chosen
that offers best contact with your video card.
Basically, any area of the video card in contact with the
original heat sink will need new heat transfer material.
Place heat transfer pads on the corresponding areas of
the Koolance water block.
3
Place the Koolance block onto the video card
so the mounting screws will align.
Unplug the heat sink fan wire. Remove the original RAM thermal transfer material,
and wipe any residual thermal material from the main GPU chipset.
There are a small number of locking tabs
around the edges of the plastic fan enclosure.
Carefully depress these with a large flat
screw driver to free the outer half of the fan
enclosure.
Carefully remove
the GPU heat sink,
followed by the card
heat sink. Original
thermal paste may
present resistance
during removal.
(VID-NX480 Only) The included LED cable can be
connected to the GTX 480 fan header.
Slide each LED light into the small receptacles
in the edge of the acrylic water block body. A
small drop of hot glue can help hold each LED
in place.