Kuryakyn 6908 TRI-LINE SADDLEBAG ACCENTS - Manual (Page 2)

PAGE
2
STEP 3 Position the Tri-Line Saddlebag Accent as shown in PIC 2.
Use masking tape to make alignment marks; remove the
Accent.
STEP 4 Use your fingernail to rub the adhesive backing; this will
activate the adhesive. Remove and discard the backing.
STEP 5 Refer to PIC 3 . Using the marks made in STEP 3 , align
the Accent and press it into place for one minute; full
bonding will occur after 24 hours. Remove and discard the
masking tape.
STEP 6 Repeat STEPS 2 through 5 for the other side.
TRI-LINE SADDLEBAG ACCENTS INSTALLATION
Ride On!
PIC 2
CLUTCH-SIDE (LEFT)
USE MASKING TAPE TO MAKE
ALIGNMENT MARKS
PIC 3
CLUTCH-SIDE (LEFT)
PRESS INTO PLACE FOR 60 SECONDS