Kuryakyn 5052 DRIVING LIGHTS FOR ROAD GLIDE - Manual (Page 2)

PAGE
2
NOTE:
This kit includes a 12-Pin Wiring Adapter that places control of the driving lights on the
motorcycle’s Accessory switch. If you already have accessories wired to
this switch, you will have to choose an alternative wiring method (sold
separately). Alternatives include replacing the stock Accessory switch
with a Küryakyn Double Rocker Switch, P/N 2201, or adding a Kuryakyn
Universal Driving Light Wiring Relay Kit, P/N’s 2202 or 2328. If you have
an empty switch location on the dash, you could purchase an OEM switch
from an authorized H-D dealership.
IT IS THE INSTALLERS RESPONSIBILITY TO ENSURE THAT
THE INSTALLATION OF THIS ACCESSORY DOES NOT EXCEED
THE MAXIMUM AMPERAGE OF THE CHOSEN CIRCUIT.
EXCEEDING THE MAXIMUM ALLOWABLE AMPERAGE MAY
LEAD TO CIRCUIT FAILURE WHICH COULD RESULT IN
SERIOUS INJURY OR DEATH.
A FACTORY SERVICE MANUAL WILL BE HELPFUL IN
PERFORMING THIS INSTALLATION.
THERE ARE SPECIFIC
PROCEDURES OUTLINED IN THE SERVICE MANUAL THAT
NEED TO BE FOLLOWED TO COMPLETE THIS INSTALLATION.
DO NOT ATTEMPT TO PERFORM THIS INSTALLATION WITH
OUT A SERVICE MANUAL OR IF YOU ARE NOT CONFIDENT IN
YOUR ABILITY TO COMPLETE ALL OF THE STEPS IN THE
PROCEDURE; CONSULT A TRAINED TECHNICIAN. IMPROPER
INSTALLATION COULD RESULT IN SERIOUS INJURY OR
DEATH.
Avoid potential electrical shock! Disconnect the battery before
starting this procedure.
STEP 2 Remove the outer fairing as described in the service manual. Disconnect the
battery.
Avoid damage to the motorcycle. Protect painted surfaces with a soft
cloth or blanket.
Assistance is recommended to secure the outer fairing after all of the torx screws
have been removed to prevent damage.
STEP 3
Locate and separate the OEM right turn signal connector. The connector is located inside the
fairing usually towards the bottom of the fairing; there will one violet wire, one blue wire, and one
black wire coming out of the connectors. Remove the right turn signal and bracket.
STEP 4 Install the right light assembly on the right mounting bracket (refer to PIC 1 to determine the
right bracket), routing the wires through the hole in the bracket.
STEP 5
Secure the light assembly to the bracket with a 1/4”-20 x 1” hex bolt and narrow flat washer.
STEP 6
Route the wires through the notch in the mounting bracket and place a driving light spacer over
the studs, routing the wires through the center hole of the spacer as shown in PIC 2.
STEP 7
Locate one of the 3-circuit AMP connectors from the hardware kit, open the secondary clasp
and insert the blue, violet and black wires into the terminal until they click (refer to PIC 3 for each
wire location in the plug). The terminal sockets will only fit in the plug correctly one way. You
should feel a click, then pulling back gently on the wire, it should feel locked in the plug. Close the
secondary clasp once all the wires have been inserted.
Küryakyn recommends the use of dielectric grease on electrical connections.
DRIVING LIGHTS/ROAD GLIDE
INSTALLATION
-cont.-
PIC 1
PIC 2
PIC 3
LEFT BRACKET
RIGHT BRACKET
ROUTE WIRES IN THE
NOTCH ON MOUNTING
BRACKET AND PLACE THE
SPACER OVER THE STUDS
BLUE WIRE
VIOLET WIRE
BLACK WIRE
SECONDARY CLASP