Kuryakyn 7263 L.E.D. REAR SADDLEBAG ACCENTS - Manual (Page 3)

PAGE
3
STEP 10
Remove the saddlebags, placing them on a soft cloth or blanket.
STEP 11 Place a piece of masking tape in the front inner portion of the saddlebag as shown
in PIC 5. Make a mark in each saddlebag with a center punch in the masking tape.
Drill a 3/8” hole in the back side of each saddlebag.
STEP 12 Starting from where the wire harness from the Accent enters at the top of the rear
of the saddlebag, cover the wire harness around the inside wall of the saddlebag
to the hole drilled in Step 11 with the included tape. (You may also use the
included cord keepers to secure the harness in the bag.)
STEP 13 Place a one of the included rubber grommets in each of the holes drilled in Step 11
and thread the excess wire harness through the rubber grommet. PIC 6
NOTE: For ‘10-up Road Glides & Street Glides, skip to STEP 18. The included
3-Pin wiring adapter is required for this installation.
NOTE: For ’93-’96 models, it will be necessary to hardwire the lights, skip to
STEP 24.
Kuryakyn recommends the use of dielectric grease on electrical
connections used in the following sections.
Wiring for ‘97 and Later FLHT, FLHR, FLHTK Models
STEP 14
Re-install the saddlebags. Remove the seat from the motorcycle and locate the
main taillight harness. PIC 7
STEP 15 Disconnect the wiring harness. Place a small amount of dielectric grease on the
8-pin connections from the main taillight wiring harness and plug the 8-Pin wiring
adapter into the ends of the main taillight harness.
NOTE: If there is a run-turn-brake controller installed, the wiring adapter needs
to be installed upstream (in front) of the controller. The installation order
MUST BE main harness from front of bike, then the 8-Pin wiring adapter,
then the controller, finally the taillight harness.
STEP 16 Route the wires from the saddlebags under the seat. Use the included cable ties to
secure the wires away from pinch points, extreme heat or moving parts.
Secure all wiring away from any moving parts, pinch points or
extreme heat. Kuryakyn WILL NOT warranty any electrical
component that fails due to pinched, crimped, broken, abraded,
melted or frayed wires.
STEP 17
Locate the male three pin connectors from the hardware kit. Connect the male
connector to one of the female three pin connectors from the wiring adapter. PIC 8
Install the pins on the Accent wire harness (PIC 9) as follows:
ACCENT HARNESS WIRING ADAPTER
WHITE RED
BLACK BLACK
RED BLUE
NOTE: Push the wires into the male connector until you feel them lightly click.
Gently pull on each wire after the click to ensure they are locked into
place.
Wiring for ’10 and Later FLHX and FLTRX Models
STEP 18 Remove the left side cover to expose the wiring harness. Locate the coiled up harness with the
black three pin connector. PIC 10
L.E.D. REAR SADDLEBAG ACCENTS
INSTALLATION
-cont.-
PIC 7
PIC 6
RUBBER GROMMET
PIC 8
INSTALL EMPTY 3-PIN
MALE CONNECTOR
PIC 9
INSERT WIRES TO LINE UP
AS SHOWN
PIC 10
3-PIN WIRING ADAPTER
CONNECT HERE