Kuryakyn 7264 SIDE TRIM for TOUR-PAK - Manual (Page 2)

PAGE
2
STEP 3 Test fit the right side Trim, lining it up to the body line above the side light
or chrome trim (PIC 2) of the right side of the Tour-Pak (PIC 2) making
any reference marks with a non-permanent marker or masking tape.
The adhesive will not bond correctly if applied at
temperatures less than 50°F. Do not attempt this installation
in temperatures less than 50°F.
STEP 4 Rub the backing of the adhesive with of your fingernail to activate the
adhesive. Remove the backing. Using any reference marks made in
Step 3, attach the Trim to the right side. Press in place for one minute.
Full bonding will occur in 24 hours.
NOTE: If the motorcycle is to be operated before the 24 hour cure time
has expired, use a good quality masking or painter’s tape over the
Trim to assist in holding the Trim in place until the cure time is
over.
STEP 5 Repeat Steps 3 and 4 for the left side.
Ride On!
SIDE TRIM for TOUR-PAK
INSTALLATION
PIC 2
USE THIS BODY LINE TO ALIGN TRIM
THIS LOCATION HAS A SIDE
LIGHT OR CHROME TRIM