Kuryakyn 4317 KINETIC FOOTPEGS - Manual (Page 2)

PAGE
2
STEP 2
Remove the stock peg from the clevis. Pay attention to any spacers or washers installed between
the male mount on the peg and the clevis, it may be helpful later. Set this hardware aside, it will
be reused.
STEP 3
Install the new peg using any spacers or washers removed in Step 2. Line up the hole on the male
mount on the new peg with the hole in the clevis.
STEP 4
Secure the peg in the clevis using the OEM hardware. Check that the peg is installed correctly and
is able to fold upward.
FOOTPEGS MUST BE INSTALLED SO THEY WILL FOLD UPWARD AND
REARWARD IF HIT BY ANY OBJECT. FAILURE TO ADJUST THE FOOTPEGS
TO OPERATE IN THIS MANNER COULD RESULT IN SERIOUS INJURY OR
DEATH.
STEP 5 Position the footpeg as desired. Using a hex wrench, tighten the 5/16”-18 socket head cap screw
located on the end of the peg. The peg mount will seat itself into the peg and keep it from
rotating.
STEP 6
Tighten all hardware securely. Insert one of the included 5/16” Hot Spots in the end of the
5/16”-18 socket head cap screw in the end of the peg.
STEP 7 Repeat Steps 2 through 6 for the other peg.
It is the installer’s responsibility to ensure that all of the fasteners (including
pre-assembled) are tightened before operation of the motorcycle. Küryakyn will
not provide warranty coverage on products or components lost due to improper
installation or lack of maintenance. Periodic inspection and maintenance are
required on all fasteners.
Ride On!
KINETIC FOOTPEGS—MALE MOUNT
INSTALLATION